- All
- Product Management
- News
- Introduction
- Corporate Outlets
- FAQ
- Corporate Video
- Corporate Brochure
How to clean an imported orifice flow meter?
Published Time:
2020-04-20 23:04
Source:
Imported orifice plate flowmeter is a measuring instrument with a relatively simple structure and very stable performance. It mainly measures the flow of liquid and steam, and is very convenient to maintain. Therefore, the application range of imported orifice plate flowmeters is very wide. So, how should an imported orifice plate flowmeter be cleaned? Today, Eletta will give you a detailed introduction.
1. To ensure the accuracy of the imported orifice plate flowmeter's measurement, it needs to be kept clean. Generally, imported orifice plate flowmeter manufacturers provide special cleaning kits, which allow cleaning operations without disassembling the sensing tube. If disassembled, the factory calibration will become invalid.
2. For imported orifice plate flowmeters in continuous use, cleaning is required every two weeks. Each cleaning session takes approximately fifteen minutes. If the readings of the imported orifice plate flowmeter are unstable, then cleaning is also necessary at this time.
3. When not using the imported orifice plate flowmeter, inspect the cleaning brush to see if it is clean and if there are any loose fibers or bristles. Then, place it in the cleaning solution. When inserting it into the flow tube, be careful and slowly push it down until there is resistance. Then slowly rotate the brush and move it up and down to collect the foam inside.
4. When performing cleaning operations on the imported orifice plate flowmeter, it is best to follow the instructions in the manual. Some steps are quite delicate and require careful operation. There should be no carelessness. For example, after removing the brush, clean warm water should be injected into the syringe.
When using the imported orifice plate flowmeter, performing good cleaning is a very important step. Everyone must not overlook this, because only by properly cleaning and maintaining the imported orifice plate flowmeter can its measurement accuracy be guaranteed, and its service life can also be extended.
Company Address:
602A, Block A, IFC Tower, No. 8A, Jianguomen Waidajie, Beijing 100022, China
Telephone:010-67189590
Fax:010-67181620
Email:eletta@eletta.cn
Quick Navigation:
Follow Us